Page 1 of 1
"think" outside the projekt size
Posted: 17 Aug 2006, 12:50
by empd
... and the second (newbie-)question ....
Can TVP "think" outside the projekt size ?
Example: The import of HDTV (1920x1080) media into a SD projekt
will autocrop my original footage (or downsize, if checkboxed)
So I can't pan around ...
Posted: 17 Aug 2006, 13:02
by ematecki
Hi,
To pan a bigger video in a smaller project, you do :
- load the big video to pan in a project by itself
- use that project as source in whatever effect you use (usually the KeyFramer for panning).
That's it.
Posted: 20 Aug 2006, 18:30
by empd
Once again thanx for that direct response.
And there it is.
The solution for "transfer modes" AND "think outside project size" ...
It is the KeyFramer !!!
Hipp-Hipp-Hooray ...
'n'
Posted: 20 Aug 2006, 19:16
by Hervé
empd wrote:
The solution for "transfer modes" AND "think outside project size" ...
It is the KeyFramer !!!
Or the multiplane camera
Posted: 20 Aug 2006, 19:26
by fabrice_
empd wrote:Once again thanx for that direct response.
And there it is.
The solution for "transfer modes" AND "think outside project size" ...
It is the KeyFramer !!!
Hipp-Hipp-Hooray ...
'n'
hi,
About the keyframer, there is an exemple in the user-manual : lesson 9 page 14 and 15.
the multiplane camera is explained in the lesson 10.
Posted: 21 Aug 2006, 10:08
by Peter Wassink
Hervé wrote:empd wrote:
The solution for ... "think outside project size" ...
It is the KeyFramer !!!
Or the multiplane camera
Or the custom brush
