Welcome to TVPaint Community forums !

Hello, bonjour,

I am working on a project a little bit bigger than my screen. I use the standard camera in some situations.
When I want to test my animations pressing play on the remote control ("Play With Camera View" is enabled) I'll get the preview at a size of 100%. Parts of the preview are hidden behind my panels or even outside my screen.

I like to have that preview at a size of let's say 70%, because I want to see the hole frame. Is there a possibility to get this?

Thanks from Animark

On the right hand side, you have different buttons (A - 1 - F and V)

Uncheck 1 and F an let A only (if I'm correct).

hmh ?,

I played with them (A - 1 - F and V), but they are not working in Fullscreen Mode (enabled by clicking on the little display on top of the screen). Till now I prevered to work in Fullscreen Mode only, is there another possibility?

They should work even in full screening :

first set the view like this :
and then, you can work in full screening :

Ah OK,

you're right. But I was a little bit inaccurate describing my wishes, sorry. I try again:

I don't want any resize of the frame between the size I am animating at and the preview. NO autoresize to anything when pressing PLAY. Excactly as when the "Play With Camera View" is not enabled. Is there a change to get that?

Okay (in fact, I misunderstood and my explanation above were wrong anyway... ^^")

When playing with the camera, it automatically resizes the point view, you can't do anything about it.

Too bad . Maybe I have to change my UI setup a little bit to find a compromise.

But many thanks for your help.