Page 1 of 1
Change line Thickness
Posted: 21 Mar 2013, 15:13
by soioartist
dear community
is it possible to increase the line thickness after drawing? via the FX stack for example?
best regards
simon
Re: Change line Thickness
Posted: 21 Mar 2013, 15:42
by Svengali
soioartist wrote:dear community
is it possible to increase the line thickness after drawing? via the FX stack for example?
best regards
simon
Take a look in FX stack panel = stylize/border effect.
Sven
Re: Change line Thickness
Posted: 21 Mar 2013, 15:53
by neonnoodle
Here's an FX stack called "Line Thickener." It's a combination of Median Blur and Curves, which first blurs the existing lines to make their radius go out farther, then threshholds the new radius to make it sharp.
- line thickener.gif (9.66 KiB) Viewed 12669 times
Re: Change line Thickness
Posted: 21 Mar 2013, 16:56
by soioartist
Sven and Neonnoodle
Thanks a lot for the hints. this is fantastic, my drawings were a little bit on the light side. both solutions work for me.
best regards
simon
Re: Change line Thickness
Posted: 21 Mar 2013, 17:08
by ZigOtto
yeap, and playing with the (unlimited) FXs combinations,
(stacking different blur modes + add boder + erode ...),
you can get many, many different results,
such as this dirty-plotty thickening for example :
- thickenLine.gif (28.06 KiB) Viewed 12662 times
Re: Change line Thickness
Posted: 21 Mar 2013, 17:39
by soioartist
brilliant! thanks!
