Page 1 of 1
Playing back camera view
Posted: 13 Jan 2016, 19:23
by David_Fine
When I chose to play back in camera view, the scene changes size. That is, I have my scene reduced in size so that I have space around it for panels, but when I playback in camera view, the image pops to fill the entire black area, which means under all the panels. This makes it hard to see the scene. Is there a way to view in camera view mode, but maintaining the image size on the screen?
Re: Playing back camera view
Posted: 14 Jan 2016, 08:02
by Elodie
Yes you're right : when playing with camera view enable, it automatically fits the window area, even if "auto fit" is disable.
Re: Playing back camera view
Posted: 14 Jan 2016, 10:30
by Mads Juul
Re: Playing back camera view
Posted: 14 Jan 2016, 10:56
by Elodie
A little bit
Re: Playing back camera view
Posted: 14 Jan 2016, 19:09
by David_Fine
Yeah, it is related. Basically, better control over the playback would be good. Any chance of that?
Re: Playing back camera view
Posted: 19 Jan 2016, 22:58
by David_Fine
Another related question. When the scene is not playing, I can see the camera position, but when I play, depending on the view mode, I either get the enlarged camera view, or I get the entire scene, without any reference to the camera. That is, the camera frame lines disappear while playing. Is there a way to maintain those lines while playing back so that I can at least see the frame lines as a guide during playback?